Tectyl Cavity Wax Non Solvent (890842)

Tectyl Cavity Wax Non Solvent is a resin/oil based, light brown/yellow, corrosion preventive.
Its nonsolvent properties ensure high efficiency, an advantageous environmental profile (almost completely free from organic solvent) and generates almost no smell.
Tectyl Cavity Wax Non Solvent is developed for industrial applications, giving good penetration into folds, flanges and cracks, as well as for the inside of car doors and other hollow sections of cars and rolling equipment.
Tectyl Cavity Wax Non Solvent cures to a light yellow, translucent, semi-soft film.

• Superior Protection Tectyl Cavity Wax Non Solvent will protect against corrosion and will displace water where needed. With the low amount of VOC, Tectyl Cavity Wax Non Solvent is also very efficient in use.
• Strong penetration With its strong penetration, Tectyl Cavity Wax Non Solvent will protect the surface against corrosion, even in small seams and crevices.

• Surface Preparation: The maximum performance of Tectyl Cavity Wax Non Solvent can be achieved only when the metal surfaces to be protected are clean, dry and free of rust, oil and mill scale and a substrate temperature of 10-35 °C at the time of product application.
• Application: Tectyl Cavity Wax Non Solvent gives a maximum performance when it is sprayed at an ambient and product temperature of 10-25 °C. Shake the can well before use and spray at a distance of approximately 30 cm from the surface. Tectyl Cavity Wax Non Solvent is fast drying, and this can cause “pin-holing” when applied too thick at once. It is advised to spray one layer per pass, wait for 2 to 3 minutes and then spray another layer. Continue like this until the required film thickness has been obtained. DO NOT FREEZE Tectyl Cavity Wax Non Solvent.
• Removal: Tectyl Cavity Wax Non Solvent can be removed with mineral spirits or any similar petroleum solvent, hot alkaline wash or low pressure steam. If dried and cured, the film of this product can also be removed with Tectyl Biocleaner.