Wynns DPF & GPF On Car Cleaner (29079)

Wynns DPF & GPF On Car Cleaner (29079) for diesel and petrol particulate filters. Wynn's DPF & GPF On-Car Cleaner with its Low Foam nonflammable formulation has been especially developed to allow workshops to clean out and restore Particulate Filters in diesel and petrol vehicles in a safe, fast and efficient way without the need to remove the filter from the vehicle.

Pré-application checks

• Check for faults codes and confirm Particulate Filter blockage
• Check engine oil level. In case of oil dilution carry out a Wynn’s Oil System Cleaner (Flush) and change the oil & filter
• Confirm vehicle has as least a ¼ a tank of fuel before commencing treatment.
• Bring vehicle up to operating temperature and switch off engine
• For Euro 6 diesel vehicles disconnect the Air Flow Sensor to prevent the low pressure EGR Valve operating during treatment

Application

• Feed the applicator tube directly into the particulate filter via either the, Metal Pressure Sensor Pipe, Temperature Sensor or Oxygen Sensor. Ensure the chosen sensor is lower than the turbo to prevent product running back into the engine
• Spray Wynn’s DPF & GPF On-Car Cleaner into the particulate filter until the can is empty
• Allow the product to soak for 15-30 minutes
• Refit the Pressure Sensor Pipe or Temperature/Oxygen Sensor
• After soak time restart engine and idle for 5 minutes, then run engine at 2,000-2,500 rpm for 5 minutes
• If Air flow Sensor was disconnected reconnect
• Clear Fault codes and reset Particulate Filter Data if required
• Carry out extended road test

Best Practice

• After treatment carry out a Wynn’s Oil System Cleaner (Flush) and an oil and Filter change
• Diesel Engines - Add one bottle each of Wynn’s Diesel Extreme Injector Cleaner and DPF Regenerator to the vehicle’s fuel tank (minimum ½ a tank of fuel)
• Petrol Engines – Add one bottle of Wynn’s GDI Efficiency Restorer and Catalytic Convertor & oxygen Sensor Cleaner to the vehicles fuel tank (minimum ½ a tank of fuel)

• H229 - Pressurised container: May burst if heated.
• H318 - Causes serious eye damage.
• P210 - Keep away from heat, hot surfaces, open flames, sparks. – No smoking.
• P251 - Pressurized container: Do not pierce or burn, even after use.
• P280 - Wear protective clothing, eye protection, face protection.
• P305+P351+P338 - IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
• P410+P412 - Protect from sunlight. Do not expose to temperatures exceeding 50°C/122°F.
• P501 - Dispose of contents/container to an approved waste disposal plant.
• EUH208 - Contains β-Alanine, N-(2-aminoethyl)-N-(2-hydroxyethyl)-, N-coco acyl derivs, monosodium salts. May produce an allergic reaction.
• 0.4 % by mass of the contents are flammable.